37
English
The outdoor unit emits water or
steam.
■ In HEAT operation
• The frost on the outdoor unit melts into water
or steam when the air conditioner is in
defrost operation.
■ In COOL or DRY operation
• Moisture in the air condenses into water on
the cool surface of outdoor unit piping and
drips.
The air conditioner does not
operate.
(OPERATION lamp is off.)
• Hasn’t a breaker turned off or a fuse blown?
• Isn’t it a power failure?
• Are batteries set in the remote controller?
• Is the timer setting correct?
Hot air does not flow out soon after
the start of HEAT operation.
• The air conditioner is warming up.
You should wait for 1 to 4 minutes.
(The system is designed to start discharging
air only after it has reached a certain
temperature.)
Operation stopped suddenly.
(OPERATION lamp flashes.)
• Are the air filters clean?
• Is there anything to block the air inlet or the
outlet of the indoor and the outdoor units?
• Clean the air filters or take all obstacles away
and turn the breaker off. Then turn it on
again and try operating the air conditioner
with the remote controller. If the lamp still
flashes, call the service shop where you
bought the air conditioner.
• Are operation modes all the same for indoor
units connected to outdoor units in the multi
system?
If not, set all indoor units to the same
operation mode and confirm that the lamps
flash.
Moreover, when the operation mode is in
AUTO, set all indoor unit operation modes to
COOL or HEAT for a moment and check
again that the lamps are normal. If the lamps
stop flashing after the above steps, there is
no malfunction. (page 30.)
01_EN_3P248442-3.fm Page 37 Tuesday, September 8, 2009 1:54 PM
To Next Page
Loading...
