Daikin FTYN20CVMB9 - Electrical Box, PCB, and Swing Motor Removal

SiENBE04-401A
Removal Procedure 147
Part 7
Removal Procedure
1. Indoor Unit...........................................................................................148
1.1 Removal of Air Filter.............................................................................148
1.2 Removal of Front Grille ........................................................................151
1.3 Removal of Horizontal Blade and Vertical Blade..................................154
1.4 Removal of Electrical Box, PCB and Swing Motor ...............................156
1.5 Removal of Heat Exchanger ................................................................162
1.6 Install of Drain Plug ..............................................................................165
1.7 Removal of Fan Rotor and Fan Motor..................................................166
2. Outdoor Unit / RK(X)S-C, ARK(X)S-C ................................................170
2.1 Removal of Panels and Fan Motor.......................................................170
2.2 Removal of Electrical Box ....................................................................177
2.3 Removal of Reactor and Partition Plate ...............................................179
2.4 Removal of Sound Blanket...................................................................181
2.5 Removal of Four Way Valve.................................................................183
2.6 Removal of Compressor.......................................................................185
2.7 Removal of PCB...................................................................................187
3. Outdoor Unit / RK(X)H-C, ARK(X)H-C, R(Y)N-C ................................190
3.1 Removal of External Panels .................................................................190
3.2 Removal of Bell mouth .........................................................................193
3.3 Removal of PCB and Electrical Box .....................................................194
3.4 Removal of Propeller Fan and Fan Motor ............................................201
3.5 Removal of Partition Plate and Reactor ...............................................204
3.6 Removal of Sound Insulation Pad........................................................207
3.7 Removal of Electronic Expansion Valve and Four Way Valve .............210
3.8 Removal of Compressor.......................................................................214