Troubleshooting by Remote Controller Si20-701_B
111
Troubleshooting
NO
The error
is displayed again.
Is the
capacity setting
adaptor connected to
the indoor unit
PCB?
Install a capacitor setting
adaptor that matches the
capacity of the indoor unit.
YES
YES
Turn OFF the power
supply and turn the power
ON.
NO
The error was
caused by a
missing capacity
resistor.
Replace the
indoor unit PCB.
Caution
Be sure to turn off the power switch before
connecting or disconnecting connectors, or parts
may be damaged.
To Next Page
Loading...
Need help?
General
