Need help?Do you have a question about the Daikin Maverick I MPSA12D and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | Maverick I MPSA12D |
| Category | Air Conditioner |
| Language | English |
General installation and operation instructions and precautions for the rooftop system.
Crucial safety warnings and precautions for unit installation and operation.
Instructions for inspecting the unit upon receipt for damage or correctness.
Details the main components of the rooftop unit and its system.
Covers installation standards, codes, and recommended NFPA publications for the unit.
Provides guidance on selecting an appropriate and safe location for unit installation.
Guidelines for installing the unit outdoors, considering drainage and snow.
Specifies minimum clearances required around the unit for proper performance and serviceability.
Crucial instructions for installing the unit on a rooftop, emphasizing structural support.
Guidelines for designing and installing ductwork, including insulation and noise reduction.
Explains the operation of the High-Gravity Reheat (HGRH) system for cooling and humidity control.
Covers gas supply piping requirements and condensate drain connections.
Outlines the procedure and safety precautions for converting the unit from natural gas to LP gas.
Instructions for installing the condensate trap and ensuring proper drainage.
Covers power supply requirements, voltage checks, and branch circuit disconnect location.
Instructions on how to wire the unit, referring to diagrams and location of entrances.
Guidelines for selecting and wiring compatible thermostats, including factory options.
Presents comprehensive data on unit capacities, airflow, and physical specifications.
Details the specifications and ratings for compressor and condenser motors across different models.
Lists Minimum Circuit Ampacity (MCA) and Maximum Overcurrent Protection (MCOP) for various voltages.
Provides characteristics and application data for auxiliary heater kits at 480V, 3-phase.
Illustrates the physical dimensions of the unit, including length, width, and height.
Provides dimensions for duct connections and roof curb installation.
Presents airflow performance data across various external static pressures and RPMs for MPS 007D.
Provides correction factors to adjust performance based on airflow and operating conditions.
Lists air resistance values for components like wet coil and economizer damper.
Lists available accessories for the unit, including their weights and part numbers.
Details the features and installation of non-DDC economizers for downflow duct applications.
Details the features and installation of non-DDC economizers for horizontal duct applications.
Details the features and installation of DDC economizers for downflow duct applications.
Details the features and installation of DDC economizers for horizontal duct applications.
Describes power exhaust kits for economizers and their components.
Describes features of motorized fresh air damper kits for DDC and modulating applications.
Details features of non-motorized fresh air damper kits, suitable for downflow and horizontal applications.
Provides information on full perimeter roof curb accessories for 7-12 ton units.
Details the two-stage integrated direct spark ignition control and its operation.
Describes the normal sequence of operation for the furnace in heating modes.
Step-by-step instructions for safely starting up and shutting down the furnace section.
Explains the function of manual reset over-temperature controls and safety warnings.
Explains pressure switches, limit controls, and associated safety warnings.
Provides general advice for unit care, including filter changes and keeping the area clear.
Details safety warnings and procedures for servicing the furnace section, including cleaning.
Recommends inspection and cleaning of evaporator and condenser coils and associated components.
Provides charging charts for 7.5 Ton AC units based on vapor pressure and outdoor ambient.
A chart detailing symptoms, possible causes, and remedies for common cooling system issues.
A flowchart to diagnose and resolve furnace heating problems, starting from the thermostat call.
Guidance on locating and obtaining Daikin certified replacement parts through the Parts Locator.
Information on warranty terms and how to find local representatives for warranty details.
Information on training resources available for Daikin equipment.
Information on finding local parts and service offices and obtaining up-to-date product information.
To Next Page