Daikin R32 Sky-Air RZAG-M - Outdoor Unit

ESIE17-08 | Part 5. Appendix 5.3. Wiring diagram
R32 Sky-Air RZAG-M
Page 120 15/11/18 | Version 1.1
5.3.2. Outdoor unit
Figure 5-2: Wiring diagram - outdoor unit RZAG-MY1, RZASG-MY1, AZAS-MY1
Notes
1. Refer to the wiring diagram sticker (on the back of the front plate) for how to use the BSI~BS3 and DS1 switches.
2. When operating, do not short-circuit protection device(s) S1PH, S1PL and Q1E.
3. Refer to the combination table and the option manual for how to connect the wiring to X6A, X28A and X77A.
4. Colours: BLK: Black, RED: Red, BLU: Blue, WHT: White, GRN: Green.
Legend
R6T Thermistor (liquid)
A1P Printed circuit board (main) R7T Thermistor (fin)
A2P Printed circuit board (noise filter) RC (A1P) Signal receiver circuit
BS1~BS3 (A1P) Push-button switch S1PH High pressure switch
C1~C5 (A1P) Capacitor S1PL Low pressure switch
DS1 (A1P) Dipswitch SEG1~SEG3
(A1P)
7-segment display
E1H * Bottom plate heater TC (A1P) Signal transmission circuit
F1U (A2P) Fuse T 6,3 A 250 V V1D, V2D (A1P) Diode
F2U, F3U (A2P) Fuse T 30 A 500 V V1R, V2R (A1P) Diode module
F6U (A1P) Fuse T 6,3 A 250 V V3R~V5R (A1P) IGBT power module
F7U (A1P) Fuse T 5 A 250 V X1M Terminal strip
F8U, F9U Fuse T 1 A 250 V Y1E, Y3E Electronic expansion valve
HAP (A1P) Light-emitting diode (service monitor is green) Y1S, Y2S Solenoid valve (4-way valve)
K1M, K3M (A1P) Magnetic contactor Z1C~Z5CS Noise filter (Ferrite core)
K1R (A1P) Magnetic relay (Y1S) Z1F~Z4F
(A1P~A2P)
Noise filter
K2R (A1P) Magnetic relay (Y2S) L*A, L*B, NA,
NBE*, U, V, W,
X*A (A1P, A2P)
Connector
K4R (A1P) Magnetic relay (E1H) * Optional
K10R
K13R~K15R (A1P)
Magnetic relay # Field supply
L1R Reactor
M1C Compressor motor
Symbols
M1F, M2F Fan motor Connection
PS (A1P) Switching power supply X1M Main terminal
Q1DI Earth leakage circuit breaker (30mA) Earth wiring
Q1E Overload protection Field supply
R1~R8 (A1P) Resistor Option
R1T Thermistor (air) Switch box
R2T Thermistor (discharge) PCB
R3T Thermistor (suction) Wiring depending on model
R4T Thermistor (heat exchanger) Protective earth
R5T Thermistor (heat exchanger middle) Field wire
Layout
OUTDOOR
Front
Back
Lower fan
Lower EEV Upper EEV
see note 3
see note 3
INDOOR
Only for RZAG100/125/140*
Position of compressor terminal
SEE
NOTE 3
4D109448
RZAG-MY1, RZASG-MY1, AZAS-MY1