Daikin R35DV1 - Jumper Settings

Si01-501 Others
Others 235
1.2 Jumper Settings
1.2.1 When Two Units are Installed in One Room

How to set the different addresses.

When two indoor units are installed in one room, the two wireless remote controllers can be
set for different addresses.
PCB in the indoor unit
FT25/35DVM, FT25/35DSG, FT09/13DV2S

Remove the front grille. (2 screws)

Remove the electrical wiring box. (1 screw)

Remove the metal plate electrical wiring cover. (3
tabs)

Cut the address jumper JA on the printed circuit
board.
FT50/60DSG, FT15DV2S

Remove the front grille. (3 screws)

Remove the electrical box (1-screw).

Remove the metal plate. (4 tabs)

Cut the address jumper JA on control PCB.
Wireless remote controller

Cut the jumper J4.
1.2.2 Jumper Setting
Screw
Address
JA
Address
JA
EXIST 1
CUT 2
tab(3)
Metal
cover
PCB
Electrical
wiring box
(R4788)
Screw
Address
JA
Address
JA
EXIST 1
CUT 2
tab(4)
Metal
cover
PCB
Electrical
wiring box
(R4789)
Wireless
remote
controller
AddressJ4
CUT
EXIST
1
2
J4
Jumper
(On indoor control PCB)
Function When connected
(factory set)
When cut
JC Power failure
recovery function
Auto re-start Unit does not resume operation
after recovering from a power
failure. Timer ON-OFF settings
are cleared.
JB Fan speed setting
when compressor is
OFF on thermostat.
Fan speed setting ;
Remote controller
setting
Fan rpm is set to “0”
<Fan stop>