Daikin R35DV1 - Discharge Pipe Temperature Control

Si01-501 Troubleshooting
Service Diagnosis 119
4.11 Discharge Pipe Temperature Control
Remote
Controller
Display
F3
Method of
Malfunction
Detection
The discharge pipe temperature control (stop, frequency drooping, etc.) is checked with the
temperature being detected by the discharge pipe thermistor.
Malfunction
Decision
Conditions

If a stop takes place 6 times successively due to abnormal discharge pipe temperature, the
system will be shut down.

If the temperature being detected by the discharge pipe thermistor rises above 120°C, the
compressor will stop. (The error is cleared when the temperature has dropped below
107°C.)

The error counter will reset itself if this or any other error does not occur during the following
60-minute compressor running time (total time).
Supposed
Causes

Refrigerant shortage

Discharge pipe thermistor defective
(heat exchanger or outdoor temperature thermistor defective)

Outdoor unit PCB defective

Water mixed in the local piping

Electronic expansion valve defective

Stop valve defective
Troubleshooting
Check No.04
Refer to P.136
Check No.06
Refer to P.137
Check No.11
Refer to P.140
Replace a defective
thermistor.
Replace the valve itself or
the coil.
Refer to the refrigerant line
check procedure.
Replace the outdoor unit
PCB.
(R4840)
Caution
Be sure to turn off power switch before connect or disconnect connector,
or parts damage may be occurred.
Check No. 06
Check the thermistors.
Malfunctioning
z Discharge pipe thermistor
z Outdoor unit heat exchanger thermistor
z Outdoor temperature thermistor
z Refrigerant shortage
z Water mixed
z Stop valve defective
Malfunctioning
Functioning
Functioning
Functioning
Check No. 11
Check the refrigerant line.
Malfunctioning
Check No. 04
Check the electronic expansion
valve.