Daikin RXQ8PY1 - Page 219

SiEN34-705
Installation Manual 213
Part 2
Installation Manual
1. Heat Pump / Cooling Only 50Hz (RX(Y)Q5~54P)...............................214
1.1 First of All .............................................................................................215
1.2 Introduction...........................................................................................218
1.3 Selection of Location............................................................................222
1.4 Inspecting and Handling the Unit .........................................................224
1.5 Placing the Unit ....................................................................................225
1.6 Refrigerant Piping.................................................................................226
1.7 Field Wiring ..........................................................................................237
1.8 Air Tight Test and Vacuum Drying .......................................................245
1.9 Pipe Insulation......................................................................................247
1.10 Checking of Device and Installation Conditions ...................................248
1.11 Additional Refrigerant Charge and Check Operation...........................249
1.12 Onsite Settings.....................................................................................256
1.13 Test Run...............................................................................................257
1.14 Caution for Refrigerant Leaks ..............................................................258
2. Heat Pump 60Hz (RXYQ5~54P).........................................................260
2.1 First of All .............................................................................................261
2.2 Introduction...........................................................................................264
2.3 Selection of Location............................................................................268
2.4 Inspecting and Handling the Unit .........................................................270
2.5 Placing the Unit ....................................................................................271
2.6 Refrigerant Piping.................................................................................272
2.7 Field Wiring ..........................................................................................283
2.8 Air Tight Test and Vacuum Drying .......................................................291
2.9 Pipe Insulation......................................................................................293
2.10 Checking of Device and Installation Conditions ...................................294
2.11 Additional Refrigerant Charge and Check Operation...........................295
2.12 Onsite Settings.....................................................................................302
2.13 Test Run...............................................................................................303
2.14 Caution for Refrigerant Leaks ..............................................................304