How to set Master Remote Controller
•
When the right to select the cooling/heating operation mode is set in the master remote controller, “ ” is
played in slave remote controllers.
The right to select the cooling/heating operation mode cannot be set in slave remote controllers.
TEST
C
H
1·2·3
BRC1C62
• When the system is installed as shown below, it is necessary to designate the master remote controller.
• Only the remote controller having the right to select the cooling/heating operation mode (master remote controller)
can select the cooling/heating operation mode.
• The displays of slave remote controllers show “ ” (CHANGEOVER UNDER CONTROL) and they automati-
cally follow the operation mode directed by the master remote controller. (This symbol is not displayed in wireless
remote controllers.)
However, it is possible to changeover to PROGRAM DRY with slave remote controller
only if the system is in COOLING
OPERATION set by the master remote controller.
When one outdoor unit
is connected with
several indoor units.
Setting the master remote controller
13
(only for 3, 4, 5, 6 hp)
dis
To Next Page
Loading...
