RA Indoor Unit SiBE18-821_C
220 Operation Manual
1. Press “ON TIMER button”.
is displayed.
blinks.
2.
3.
4. Press “CANCEL button”.
To combine ON TIMER and OFF TIMER
ATTENTION
1, 3
4
2
(Example)
Present time: 23:00
(The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
• Check that the clock is correct. If not, set
the clock to the present time.
Press “SELECT button” until
the time setting reaches the
point you like.
•
Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
Press “ON TIMER button”
again.
To cancel ON TIMER
operation
In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
To use ON TIMER
operation
• The TIMER lamp lights up.
• The TIMER lamp goes off.
• A sample setting for combining the two timers is shown below.
To Next Page
Loading...
Need help?
General
