SiBE18-821_C SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series
Operation Manual 261
Operation manual
9
BRC1D528
Remote controller
4PW23717-1
NOTE
NOTE
NOTE
NOTE
The button is used to exit browsing at once
(without having to scroll through all programmed
actions).
Press the button to enter the browse mode, the
icon appears, will blink.
Browsing always starts on Monday and
ends on Sunday.
Check the icon. If at least 1 action is
programmed for Monday, will appear.
The clock indicates the time when the programmed
action is scheduled, either , or and
is being displayed.
The temperatures mentioned above are
for clarifying purposes only, temperature
values on your controller may vary.
If does not appear, it indicates that there are no
programmed actions for Monday.
Press the button again to go to the next day of
the week. will blink, this indicates that the
programmed actions for Tuesday are being browsed.
The process described above is now restarted.
If at least 1 action is programmed for Tuesday, will
appear. The clock indicates the time when the
programmed action will be enabled, either ,
or and is being displayed.
If does not appear, it indicates that there are no
programmed actions for Tuesday.
Press the button to display the next programmed
action. If a second action is programmed for Tuesday,
will still be blinking and will appear.
Assuming that 5 actions were programmed for
Tuesday, a total of 5 presses will be required to
display all programmed actions.
Continue pressing the button until the day of the
week indicator displays the current day (not blinking),
you have now quit browsing.
The number of times that the button
will have to be pressed to quit browsing
depends on the number of programmed
actions in the schedule timer.
How do I interpret the programmed
actions
To be able to understand the behaviour of your
installation when the schedule timer is enabled, it is
important to look at all programmed actions for the
current day and maybe the last programmed action of
yesterday.
If the first programmed action for today is not active
yet, the current status of your installation depends,
most probably but not necessarily, on the last
programmed action from yesterday. Read the
important note below.
If the first programmed action for today is already
active, the current status of your installation depends,
most probably but not necessarily, on the parameters
programmed in the first programmed action for today.
Read the important note below.
To keep the operation of your installation
simple, the schedule timer settings can
easily be overruled by altering the current
setting ("last command" overrules
previous command until next scheduled
command).
Conclusion: Although is displayed, somebody
might have altered the settings. The next
programmed action will overrule the altered settings
and all settings return as programmed.
To Next Page
Loading...
Need help?
General
