Daikin Trailblazer AGZ030E-070E - Page 141


www.DaikinApplied.com 141 IOM 1207-6 • TRAILBLAZER
®
MODEL AGZ CHILLERS
NON-MICROTECH READINGS
MICROTECH SETPOINTS
SF-20001 AGZ/AMZ Start-Up 8/2020 4 of 8 www.DaikinApplied.com
G. Circuit #2 Refrigerant Temperatures:
Saturated Evaporator Temperature …………………… °F (°C) °F (°C)
Suction Line Temperature ………………………………. °F (°C) °F (°C)
Suction Superheat …………………………………….... °F (°C) °F (°C)
Saturated Condenser Temperature …………………… °F (°C)
Liquid Line Temperature …………………………………………………………… °F (°C)
Subcooling ………………………………………………………………………….. °F (°C)
Discharge Temperature …………………………………………………………… °F (°C)
H.Ambient Air Temperature: ……………………………………………………….. °F (°C) °F (°C)
I. Does the system contain glycol? Yes No
Percentage by weight or by volume Glycol Type
J. If the chilled water system include glycol, have the freeze protection, low pressure devices and settings
been adjusted for the actual job requirements? Detail these settings on page 8 - Remarks section
Note: See operation manual for low temperature on ice bank applications.
Yes No
K. Unit Voltage Across Each Phase: L1-L2 V L1-L3 V
L. Unit Current Per Phase: L1 amps
V L2-L3
L2 amps L3 amps
M. Compressor Current Per Phase: Compressor #1: L1 Amps L2 Amps L3 Amps
L1 Amps L2 Amps L3 Amps
L1 Amps L2 Amps L3 Amps
L1 Amps L2 Amps L3 Amps
L1 Amps L2 Amps L3 Amps
Compressor #2:
Compressor #3:
Compressor #4:
Compressor #5:
Compressor #6: L1 Amps L2 Amps L3 Amps
MICROTECH Setting
A. Leaving Evaporator ………………………………………………………………….. °F (°C)
B. Reset Leaving ……………………………………………………………………… °F (°C)
C. Reset Signal ……………………………………………………………………… ma
D. Reset Option ………………………………………………………………………
E. Maximum Chilled Water Reset …………………………………………………. °F (°C)
F. Return Setpoint …………………………………………………………………….. °F (°C)
G. Maximum Pulldown ……………………………………………………………… °F (°C)
H. Evaporator Full Load Delta T ……………………………………………………… °F (°C)
I. Evap Recirc Timer …………………………………………………………………. sec.
J. Start-to-Stop Delay ………………………………………………………………….. min.
K. Stop-to-Stop Delay …………………………………………………………………… min.
L. Stage Up Delay ………………………………………………………………………. sec.
M. Stage Down Delay ………………………………………………………………….. sec.