Daikin VAM2000J8VEB - Page 41

13 | About the units and options
Installer and user reference guide
41
VAM350~2000J8VEB
Heat reclaim ventilation unit
4P664012-1 – 2021.08
Plenum (EKPLEN200)
The plenum is an option for models 1500 and 2000. This option can be used to
ease the installation of the heat reclaim ventilation unit.
Replace the 2 duct joints of Ø250 mm with the plenum and a duct joint of
Ø350mm.
For installation instructions, see the installation manual of the plenum kit.
EKVDX module
The EKVDX module is an option for the heat reclaim ventilation unit. It can be used
to heat up or cool down fresh, outdoor air coming from the heat reclaim
ventilation unit, for lower load on the air conditioning system.
For more information, see "16.5 EKVDX option"[467].
Use the table to make the correct selection between the capacities of the heat
reclaim ventilation unit and the EKVDX.
EKVDX32 EKVDX50 EKVDX80 EKVDX100
VAM500J8 ● — — —
VAM650J8 — ● — —
VAM800J8 — ● — —
VAM1000J8 — — ● —
VAM1500J8 — — — ●
VAM2000J8 — — — ●
— Not compatible
● Compatible in pair
CO
2
sensor (BRYMA*)
The CO
2
sensor is optional. This option can be used to adapt the ventilation rate to
the CO
2
concentration.
Install the CO
2
sensor in the heat reclaim ventilation unit. For models 1500+2000,
install the CO
2
sensor in the top heat reclaim ventilation unit.
For installation instructions, see "17.5.3About the CO₂ sensor"[490].