IM 1240-4 • INTELLIGENT EQUIPMENT 26 www.DaikinApplied.com
The 120VAC cable has the jacket and insulation pre-stripped,
with the ends of both the Line and Neutral wires tinned. On a
MicroTech III Rebel unit, connect the Line (brown) conductor
to terminal TB1-1 and the Neutral (blue) conductor to terminal
TB1-3 (Figure 58).
On a MicroTech III Maverick II unit, connect the Line (brown)
conductor to terminal TB1A-1, 2, 3, or 4 and the Neutral (blue)
conductor to terminal TB1A-5, 6, 7, 8, or 9 (Figure 59).
On a MicroTech III RPS, RPR, RDT, RFS, RDS or RAH unit,
connect the Line (brown) conductor to terminal TB1A-1, 2, 3, or
4, and the Neutral (blue) conductor to terminal TB1A-5, 6, 7, 8,
or 9 (Figure 60).
Figure 58: Typical MicroTech III Rebel 120VAC Wiring
Figure 59: Typical MicroTech III Maverick II 120VAC Wiring
Figure 60: Typical MicroTech III RoofPak Unit 120VAC Wiring
To Next Page
Loading...
