Removing Collected Water
1. In Cool, Dry or Heat mode operating, the condensation water will be drained to
■ Drainage way as follows.
the chassis.
2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is
displayed to remind user to discharge water:
● Move the unit to a suitable place for discharging water; do not tilt the unit and
keep it horizontal during moving;
● Take the drainage pipe from the clip and pull out the rubber plug on the
drainage pipe to discharge water;
● After full water protection is eliminated and the compressor has been stopped
for 3 minutes, the unit will resume operation.
22
To Next Page
Loading...
