The installation must be done following the current regulation, according to the instructions of the
manufacturer and of qualified personnel.
Carefully read the instructions and the warnings contained in this manual because they give important
indications about the installation of the machine and its functioning.
Check that the installation systems have been prepared according to the instructions contained in this
manual .
Check that the electric capacity of the user’s system is appropriated for the highest power of the machine
of the equipment indicated on the data plate of the machine .
In case of replacement of the supply pipe of the machine, only use the cable adviced by the
manufacturer.
The electrical safety is only achieved when the machine is correctly connected to an earthing
installation.
The machine must exclusively be fed with cold drink- water. The maximun network pressure must be
0.6 Mpa.
Moreover, the use of any electric appliance requires some basic rules:
• do not touch the machine with wet hands or feet.
• do not use the machine when barefoot.
• do not let non-supervised children or non-authorized people use the machine
• do not wash the machine with a jet of water
• do not leave the machine switched on and unattended
• before performing any washing operation or any regular maintenance , disconnect the machine
from the electric network and close the water feed tap
• In order to grant a complete efficiency of the machine and its perfect functioning it is essential to
follow the constructor’s instructions
• In case of damage and/or bad functioning switch the machine off, do not try to perform any direct
maintenance and address the problem to the Assistance Centre authorized by the manufacturer.
TECHNICAL DATA
1. Water tap
2. Flexible water hoses
3. Water softener (optional)
4. Drain Hose
5. Drain siphon
6. Electrical supply cable
7. On/Off switch
A. Opening on the support plan
B. Space under the support plan
A- Opening on support surface
B- Under counter space
To Next Page
Loading...
