The coffee doses are programmed in the following way:
• Keep on pressing the button P3 of the keyboard until all the three leds light up
(about 30”)
• Prepare the 1- dose filterholder and press the button P1( coffee supplì starts),
when You get the quantity you want ,press the button P3 to stop (the led of the
button P1 switches off)
• Repeat the procedure with the dose for 2 and press the button P2 (coffee
supply starts) , when You get the quantity you want ,press the button P3 to
stop ( only the led of the of the button P3 stays on)
• In order to record the doses and finish the procedure , press again the button P3
(the corresponding led switches off too).
HOW TO PROGRAM THE PRE-INFUSION TIME
It is possible to regulate the pre-infusion time as follows:
While you keep on pressing the button P1 , turn on the machine; the led of button
P1 will lighten , turn off the machine and turn it on again , in this way you have set
the pre-infusion time at 4 s.
If You prefer a shorter time (2 s), perform the same operation but press the button
P2 instead of P1, the led of button P2 will then lighten up.
In order to cancel the pre-infusion time completely, follow the procedure described here
above but press button P3 when you turn on the machine; the corresponding led will
lighten up, then switch off and on again the machine
ELECTRIC INSTALLATION
To Next Page
Loading...
