Serie "LXS9"
Pagina A - 7
D) This message appears on the display:
If the product drop sensors (FTCA) are installed on the vending machine, XXX = ON
If the product drop sensors (FTCA) are not installed on the vending machine, XXX = OFF
press F to confirm
E) After a short time, the sliding panel will perform a cycle of opening and closing, if appears “OFF L13b
SD Motor Disconnected”, it is necessary to turn on the door open switch and press any button to check
the open/close cycle.
Once the open/close cycle is complete, if any other problem is not found, you can pass directly to the “F”
point , if wrong opening and closing times of the sliding panel values are found, there will appear the
following message on the display:
Press 1 key to perform the automatic calibration of time/speed of opening/closing of the sliding panel. At
the end of the test the following message appears on the display:
press F to confirm
F) The following message will appear shortly on the display:
Possible values: 0, 1, 2:
If the value is „0‟ (zero), there is no refrigerator probe connected; the following message will appear when
F is pressed:
With “OFF” mode, refrigerator operation is deactivated; the self-learning procedure ends when the F key
is pressed and the vending machine returns to the programming menu. No other modes can be selected.
If the value is „1‟ (One), there is just one refrigerator probe connected; the following message will appear
when the F key is pressed:
It is possible to confirm “Drink & Snack” mode or, alternatively, select the “OFF” mode.
In “Drink & Snack” mode, refrigerator operation is activated without management of the safety temperature
of the food zone; the self-learning procedure ends when the F key is pressed and the vending machine
returns to the programming menu.
If the value is „2‟ (Two), there are two refrigerator probes connected; the following message will appear
when the F key is pressed:
or,
It is possible to confirm “FOOD & Snack” mode or, alternatively, select the “Drink & Snack” mode or “OFF”.
Management of the safety temperature is activated when “FOOD & Snack” mode is selected; the following
message will appear when the F key is pressed:
The safety temperature value is displayed with the possibility of changing it; press F to confirm.
If an incorrect message appeared on the display during phase F), carry out the operations described in the
“Installation and service” manual, referring to the “OFF L01 and OFF L02” messages.
Self-learning
FTCA sensors:XXX
Self-learning
Conn. probes x
Security Temper.
*> 7.0°C
Refrig.operation
Drink & Snack
Refrig.operation
Drink & Snack
Refrig.operation
FOOD & Snack
Pannel. Scorrev.
1)Test 2)Skip
O:xxx C:xxx Pxxx
TO:xxxx TC:xxxx
To Next Page
Loading...
Need help?
General
