Features
ELECTRONIC CONTROL
INSTRUCTIONS
6
POWER button
Turns power on/off.
FAN button
Controls the fan speed. Press to toggle between three fan
speeds, Maximum, Medium and Low
UP and DOWN buttons
Used to adjust (increase / decrease) temperature settings
(1°C/1°F increments) in a range of 18°C(64°F) to 32°C(90°F)
or the TIMER setting in a range of 1~24hrs. The control is
capable of displaying temperature in degrees Fahrenheit or
degrees Celsius. *Converting from °C to °F can be done using the
remote control by pressing the °C/°F button.
MODE select button
Selects the appropriate operating mode. Each time you press
the button, a mode is selected in a sequence that goes from
COOL, DRY, and FAN. The mode indicator light illuminates
depending on the mode settings.
LED DISPLAY
Shows the set temperature in °C or °F (to toggle between °C and °F
press the °C/°F button on the remote control).
Error codes:
LT - Low Temperature. The unit will defrost. The appliance will
start again once defrosting is complete.
PF - Probe failure, call for service.
FT- Tank is full - Connect the drain hose and drain the
collected water away. If error repeats, call for service.
1
2
4
3
4
To Next Page
Loading...
