User manual for DM700 ECDIS hardware
Copyright Danelec Marine A/S
MAN11804-10 Page 28/30
3. Verify the DM700 ECDIS is turned on (Status LED must be GREEN). If not, briefly press
the “POWER” button on the monitor HMI, or briefly press the “POWER” button on the
DPU 700-01, next to the Status LED
4. If the message “No boot media found” appears, verify the M.2 SATA SDD is inserted in the
M.2 SATA connector under the service cover. If M.2 SATA SDD is inserted, the M.2
SATA connector or M.2 SATA SDD is defective. Contact a Danelec service partner for
further assistance.
5. If the message “Operating system not found” appears, the ECDIS system software is not
installed properly and must be reinstalled. Contact a Danelec service partner for further
assistance.
To Next Page
