Need help?Do you have a question about the Danfoss BasicPlus2 WT-DM and is the answer not in the manual?
General| Brand | Danfoss |
|---|---|
| Model | BasicPlus2 WT-DM |
| Category | Thermostat |
| Language | English |
Turn the thermostat ON or OFF by pressing the power button.
Adjust the desired temperature using the < or > buttons; display shows SET.
Enter Away mode by pressing M, set point with < or >, exit by pressing M.
Press and hold M, then < to display floor temperature; exits automatically.
Press and hold M, then > to lock buttons; press again to unlock.
Configures the thermostat operation (Manual or Programmable Timer).
Selects between room temp., room and floor temp., or only floor temp.
Sets the maximum allowable room temperature.
Sets the minimum allowable room temperature.
Enables high or low temperature limitation for the floor.
Sets the specific limit for floor temperature.
Sets the maximum allowable floor temperature.
Sets the minimum allowable floor temperature.
Enables or disables the frost protection function.
Sets the temperature for frost protection.
Configures the timer display to show 24h or 12h format.
Determines if current room temp is displayed when thermostat is shut down.
Assigns a unique address for MODBUS communication.
Sets the data transmission speed for MODBUS communication.
Configures the parity check for MODBUS data integrity.
Indicates a problem with the room temperature sensor.
Indicates a problem with the floor temperature sensor.
Indicates a failure in the thermostat's memory.
Indicates the detected temperature is below 0° C.
Indicates the detected temperature is above 50° C.
To Next Page
