Need help?Do you have a question about the Danfoss TP4000 Range and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Mounting | Wall-mounted |
| Accuracy | ±0.5°C |
| Protection Class | IP30 |
| Temperature Range | 5°C to 30°C |
| Power Supply | Battery powered (2x AA) |
| Switch Rating | 3(1)A 230V AC |
| Switching Current | 3A |
| Type | Electronic Room Thermostat |
Explains the function and daily operation of the TP4000 thermostat.
Details the default time and temperature settings pre-programmed into the TP4000.
Instructions for initial setup, including pressing the RESET button to ensure factory settings.
Step-by-step guide to setting the correct time on the TP4000 thermostat.
How to activate and run the programmed settings on the TP4000.
Notes on sequential programming and returning to RUN mode during advanced settings.
Detailed steps for modifying the pre-programmed event times and temperatures.
Confirms how to run the programme after making changes, indicated by a flashing colon.
Explains how to temporarily adjust heating behaviour without altering the core programme.
How to switch the thermostat display between showing the current time and room temperature.
Procedure to manually adjust the temperature temporarily until the next programmed event.
How to set a constant low temperature for frost protection or select different thermostat modes.
Instructions to change the clock display format between 12-hour and 24-hour modes.
How to toggle the temperature display between Celsius (°C) and Fahrenheit (°F) scales.
Guide on how to replace the batteries when they are low, including important notes.
Instructions for performing a partial reset (restart) or a full reset to factory defaults.
To Next Page
