Danfoss Heating
7
GB
FR
ES
NL
GR
PL
CZ
TR
HR
RO
HU
LT
GB
1.4 Setting the Clock
Note: clock is displayed in 24 hour mode.
Press PROG and Λ until the time on the display
fl ashes.
Use + or - to adjust the TIME (press and hold to
change in 10 min increments).
Press PROG to enter the TIME.
1.5 Running your programme
If you are happy to use the preset programmes
on page 6, you don’t need to do anything else.
Your unit is now in RUN mode.
2.0 Advanced
2.1 Before you change the preset programmes
Please Note
The unit must be programmed in sequence. Event times cannot
be programmed out of sequence.
If you want to leave a preset time as it is, simply press PROG to
move on to the next setting.
During programming, if no buttons are pressed for 2 minutes the unit
will automatically return to RUN mode, and the programme set up to
that minute will be active.
To Next Page
Loading...
