Need help?Do you have a question about the Danfoss TP5000 si range and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Temperature Range | 5°C to 30°C |
| Switching Voltage | 230V AC |
| Frost Protection | Yes |
| Accuracy | ±0.5°C |
| Protection Class | IP30 |
| Type | Room thermostat |
| Programming | Programmable |
| Power Supply | Battery |
| Battery Type | 2x AA |
| Mounting | Wall Mount |
| Ambient Temperature | 0°C to 40°C |
| Switching Current | 5A (resistive) |
Describes the product as a 5/2 day programmable room thermostat for electronic control.
Indicates the document provides installation and user guidance for the thermostat.
Provides detailed technical specifications for the TP5000 Si range of thermostats.
Guidance on the correct placement and mounting of the thermostat and its remote sensor.
Details the electrical wiring connections for different models of the thermostat.
Steps required to commission RF models, including pairing with receiver units.
Details advanced features configurable by installers to optimize system performance.
Step-by-step guide on how to access the advanced installer programming menu.
Configuration option to electronically limit the thermostat's upper temperature setting.
Configuration option to electronically limit the thermostat's lower temperature setting.
Sets the thermostat to operate in either 5/2 day or 24 hour mode.
Sets the thermostat's operating mode to On/Off or Chrono-proportional.
Allows the type of remote sensor input to be defined for 'A' models.
Sets the limit sensor set-point for 'A' models, typically for floor heating.
Guide on how to enter the User Advanced Programming mode.
Sets the pre-heat period for Optimum Start Control to match building energy characteristics.
Configures how the thermostat starts up the system (Normal, OSC, or Delay Start).
Describes unit behavior and installer options during battery failure.
To Next Page
