Danfoss TP5000 si range User Manual

18
Setting the date
Press and hold Λ and PROG for 3 seconds, to display
date in dd/mm/yy format.
The YEAR number will  ash, use Λ or V to correct
the year.
Use - or + to move to MONTH, then use Λ or V to
correct month.
Use - or + to move to DATE in month, then use Λ or
V to correct day in month.
If you attempt to select an invalid date the unit software will reject it
and apply the nearest valid date. It is recommended that date is set in
the order, yy/mm/dd.
Setting the correct time
After setting the date press PROG to display the
time. The time display will  ash on and o .
Use the + and - buttons to set the correct
time (press and hold to change in 10 min.
increments).
Setting the correct day
The day of the week is set automatically. Press
PROG to return to normal operation (RUN).
User Instructions
GB

Danfoss TP5000 si range Specifications

General

Display	LCD
Temperature Range	5°C to 30°C
Switching Voltage	230V AC
Frost Protection	Yes
Accuracy	±0.5°C
Protection Class	IP30
Type	Room thermostat
Programming	Programmable
Power Supply	Battery
Battery Type	2x AA
Mounting	Wall Mount
Ambient Temperature	0°C to 40°C
Switching Current	5A (resistive)