Danfoss TP5000 si range User Manual

8
Installer advanced programming options
TP5000 Si incorporates an additional number of advanced features
which can be set by the installer to improve the operating e ciency of
the system and where required, to change the user functionality of the
product. These are accessed via an Installer Advanced Programming
Mode. These settings are optional and need only be made if there is a
demand for the enhanced functions.
Installer advanced
programming options
TP5000 Si incorporates a number of advanced features which can be
set by the user. These are accessed via a User Advanced Programming
Mode, please refer to User Advanced Programming in the user
instructions for details (see page 25).
Step 3
RX1 - Press and hold buttons PROG and CH1 for 3
seconds until green light  ashes once.
Step 4
RX2 (if applicable)
Stat 1 - perform steps 1-3 and 5.
Stat 2 -perform steps 1-2 and then press PROG and CH2 on RX2.
RX3 (if applicable)
Stat 1 - perform steps 1-3 and 5.
Stat 2 - perform steps 1-2 and then press PROG and CH2 on RX3 then
step 5.
Stat 3 - perform steps 1-2 and then press PROG and CH3 on RX3.
Step 5
TP5000Si-RF - Press V or Λ to select temperature - the unit will revert
back to operating mode.
Installation Instructions
GB

Danfoss TP5000 si range Specifications

General

Display	LCD
Temperature Range	5°C to 30°C
Switching Voltage	230V AC
Frost Protection	Yes
Accuracy	±0.5°C
Protection Class	IP30
Type	Room thermostat
Programming	Programmable
Power Supply	Battery
Battery Type	2x AA
Mounting	Wall Mount
Ambient Temperature	0°C to 40°C
Switching Current	5A (resistive)