Danfoss TP5000 si range User Manual

4
Installation Instructions
GB
Installation
 First, remove the wallplate from the back of the unit.
 From the top left hand corner of the wallplate, there must be
clearances of at least 15mm to the right, 15mm to the left, 30mm
above and 100mm below in order to mount the plug-in module.
 Thermostat and Remote Room Sensor:
Fix at a height of approximately 1.5m from the  oor, away from
draughts or heat sources such as radiators, open  res or direct
sunlight.
 Prior to mounting the unit the 2 DIL switches on the rear of the
unit have to be moved to the required position. The factory
presets are shown below.
1
2
Keyboard disabled
Reset disabled Reset enabled
Keyboard enabled
OFF
ON
Sw. No.

Danfoss TP5000 si range Specifications

General

Display	LCD
Temperature Range	5°C to 30°C
Switching Voltage	230V AC
Frost Protection	Yes
Accuracy	±0.5°C
Protection Class	IP30
Type	Room thermostat
Programming	Programmable
Power Supply	Battery
Battery Type	2x AA
Mounting	Wall Mount
Ambient Temperature	0°C to 40°C
Switching Current	5A (resistive)