Need help?Do you have a question about the Danfoss BasicPlus2 WT-T and is the answer not in the manual?
General| Type | Electronic thermostat |
|---|---|
| Communication | Wired |
| Accuracy | ± 0.5 °C |
| Protection Class | IP30 |
| Mounting | Wall-mounted |
| Power Supply | 230 V |
Install thermostat approx. 1.5 m above floor, avoiding heat sources and draughts.
Carefully remove the thermostat cover and dial knob before installation.
Connect wires before mounting the back plate, then attach the cover.
Connect to TWA 230 V NC or NO actuator when power supply is close.
Connect to TWA 230 V NC or NO actuator when power supply is close.
Ensure correct wiring (L, N) and prevent short circuits from exposed wires.
Avoid damaging wire insulation with screws to prevent short circuits.
Mount thermostat after painting to prevent dust or paint ingress.
Max load is 3A resistive or 1A inductive; exceeding limit damages the relay.
Do not cover the thermostat with items like towels to ensure proper function.
Connect the room thermostat to the corresponding loop actuator for control.
To Next Page