Danfoss CF-RF - Page 8

7VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007
Instruction CF-RF Room Thermostat with Infrared Floor Sensor
Setting of room temperature
1. Make sure actual room temperature is shown
in the display
2. Press the up/down selector to set the
desired room temperature value. SET is shown
in the display
3. When releasing the up/down selector the
display returns to actual temperature
Note: The thermostat regulates the oor heating system
according to room temperature set point, within the
maximum and minimum limitations dened for the oor
surface temperature
Room temperature limitation
1. Make sure actual room temperature is shown
in the display
2. Press the push button until SET MAX is
shown in the display
3. Press the up/down selector to set the
maximum room temperature limitation
4. Press the push button shortly, SET MIN is
shown in the display
5. Press the up/down selector to set the
minimum room temperature limitation
6. Press the push button shortly and the
actual oor surface temperature is shown in
the display
GB