These instructions describe the replacement of the control card in:
•
VLT
®
HVAC Drive FC 102.
•
VLT
®
Refrigeration Drive FC 103.
•
VLT
®
AQUA Drive FC 202.
•
VLT
®
AutomationDrive FC 301/FC 302.
•
VLT
®
Lift Drive LD 302.
Safety Instructions
Only Danfoss authorized, qualied personnel is allowed to repair this equipment.
WARNING
DISCHARGE TIME
The frequency converter contains DC-link capacitors, which can remain charged even when the frequency converter is not
powered. High voltage can be present even when the warning LED indicator lights are o. Failure to wait the specied time
after power has been removed before performing service or repair work can result in death or serious injury.
•
Stop the motor.
•
Disconnect AC mains and remote DC-link power supplies, including battery back-ups, UPS, and DC-link connections to
other frequency converters.
•
Disconnect or lock PM motor.
•
Wait for the capacitors to discharge fully. The minimum duration of waiting time is specied in Tab l e 1 . 1 to Tab l e 1 . 5.
•
Before performing any service or repair work, use an appropriate voltage measuring device to make sure that the
capacitors are fully discharged.
Installation Instructions
Control Card VLT
®
FC Series
Danfoss A/S © 03/2017 All rights reserved. MI93A102
To Next Page
Need help?
General