Danfoss DHP-A Installation Instruction

6
VMBMF302
1.7 Assembling the defrost sensor
Figure 8: Hook the defroster sensor into place.
18. Slide the mounting for the defroster sensor into the hole on the reverse of the outdoor unit until it hooks into place on
the edge.
19. Secure the defroster sensor at the bottom of the mounting using a cable tie.
The outdoor unit is now mounted and can be adjusted on the site where it should be set up.

Danfoss DHP-A Specifications

General

Brand	Danfoss
Model	DHP-A
Category	Heat Pump
Language	English