Danfoss Heating
13
GB
Fig. 14 Fig. 15 Fig. 16
1.7.3 Programming in 5+2 day mode
(One set of programmes for weekdays, another for weekends)
a) Press PROG button until Event 1 ashes, then press the DAY
button until display shows weekdays (Fig. 14).
b) Follow steps b and c on page 11 to programme times for
weekdays (Fig. 15).
c) Press the DAY button to programme events for weekend (Day
6-7) or press the COPY button to repeat weekday programme.
To return to RUN mode, press and release the PROG button. The
display will change to show the current time (Fig. 16).
Copy Function has been enabled in option 2 in Advanced
Programming (see page 20).