EasyManuals Logo

Danfoss FP735Si User Manual

Danfoss FP735Si
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
FP735SI
14
GB
1.7.4 Programming in 24 hour mode
(Every day of the week uses the same programme)
a) Press the PROG button until event 1  ashes (Fig. 17).
b) Amend the time as follows:
i) Press the + and buttons to alter the time (press and hold to
move in 10 minute increments).
ii) Press the NEXT button to advance to the next event (Fig. 18).
iii) Repeat the steps above for the remaining events.
c) When all events are programmed press the PROG button to
return to RUN mode (Fig. 19).
1.7.5 Programming in A+B mode
(The Advanced Programming parameter 6
must be set to 5+2 days)
Press and hold the PROG and V buttons for 3 seconds.
The display will change to that shown in Fig. 20. This
will take you into Advanced Programming Mode
option 1.
Use the Λ or V buttons to enable or disable the
function (1=enabled, 0=disabled).
Fig. 20
Fig. 17 Fig. 18 Fig. 19

Other manuals for Danfoss FP735Si

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss FP735Si and is the answer not in the manual?

Danfoss FP735Si Specifications

General IconGeneral
BrandDanfoss
ModelFP735Si
CategoryTemperature Controller
LanguageEnglish

Related product manuals