Danfoss FP735Si - Page 9

Danfoss Heating
9
GB
Setting the date
Press and hold Λ and PROG buttons for 3
seconds, to display date.
The YEAR number will  ash, use Λ or V to
correct the year (Fig 1).
Use - or + to move to MONTH, then use Λ
or V to correct month (Fig 2).
Use - or + to move to DATE in month,
then use Λ or V to correct day in month
(Fig 3).
If you attempt to select an invalid date
the unit will reject it and apply the nearest
valid date. It is recommended that date is
set in the order, yy/mm/dd.
Setting the correct time
After setting the date press PROG to
display the time. The time display will
 ash on and o . Use the + and - buttons
to set the correct time (press and hold to
change in 10 minute increments). (Fig. 4)
Fig. 3
Fig. 4
Fig. 1
Fig. 2