Danfoss iC7 Series

4.
1.
2.
3.
4.
With the rubber seals in place, carefully slide the inner sleeve of the duct into the outer sleeve
e30bj178.10
1
2
3
Illustration 12: Assembly of Telescopic Duct
1
Inner sleeve of duct
2
Ribbed EPDM rubber seal
3
Outer sleeve of duct
2.10 Installing the Bottom Duct
To attach the bottom duct to the base plate of the cabinet, use the following steps. Refer to Illustration 13.
Procedure
Install the base plate in the Rittal cabinet using the existing fasteners.
Collapse the bottom duct and position it over the vent cutout in the base plate.
Place the holes in the lower flange of the duct over the holes surrounding the opening in the plate.
Fasten 4 M5x10 screws (T25) through the holes in the lower flange of the duct, securing it to the base plate.
AN371942757356en-000101 / 136R0252 | 15Danfoss A/S © 2022.03
Installation
In-bottom/Out-back Cooling Kit for FA09-FA10
Installation Guide