Danfoss iC7 Series

5.
1.
Extend the duct upward and fasten with 6 M5 hex nuts, securing it to the duct support plate.
1
2
3
6
5
4
e30bj142.10
Illustration 13: Installation of the Bottom Duct
1
M5 hex nut
2
Bottom telescopic duct
3
M5x16 screw
4
Base plate
5
Duct support plate
6
Lower flange of duct
2.11 Installing the Back Vent
To install the back vent, use the following steps. Refer to
Illustration 14.
Procedure
Slide 6 clip-on nuts over the edge of the vent opening in the backplate of the cabinet.
AN371942757356en-000101 / 136R025216 | Danfoss A/S © 2022.03
Installation
In-bottom/Out-back Cooling Kit for FA09-FA10
Installation Guide