OPTYMA
TM
Control single-phase AK-RC 101 RS8FD402 © Danfoss A/S 2014/11 5
1.
Lift the transparent cover.
Remove the screw cover on the
right-hand side of the housing.
Installing the unit
2.
Undo the 4 xing screws at the
front of the housing.
3.
Open the front of the housing, lift
it and slide the two hinges out as
far as they will go.
4.
Press on the sides of the hinges
to remove them from their seats
and then remove the front panel
completely.
To Next Page
Loading...
