VLT® 5000 Crane
The chosen digit is indicated by the digit flashing. The
bottom display line shows the data value that will be
entered (saved) when signing off with [OK].
■ Manual initialization
Manual initialization is performed as follows:
Cut mains. Hold the [DISPLAY STATUS] + [CHANGE
DATA] + [OK] keys down, and simultaneously
reconnect the mains. Release the keys; the frequency
converter has now been programmed for the
factory setting. The following parameters are not
reset during manual initialization:
- par. 600 Operating hours
- par. 601 Hours run
- par. 602 kWh counter
- par. 603 Number of power-ups
- par. 604 Number of overtemperatures
- par. 605 Number of overvoltages
■ Infinitely Variable Change of NumericData Value
If the chosen parameter represents a numeric data
value, a digit is first selected by means of the [<>] keys.
50.0 HZ
SETUP
1
FREQUENCY
102 MOTOR POWER
0.37 KW
Then the chosen digit is changed infinitely variably
by means of the [+/-] keys:
SETUP
1
50.0 HZ
FREQUENCY
102 MOTOR POWER
0.55 KW
SETUP
1
The chosen digit is indicated by the digit flashing. The
bottom display line shows the data value that will be
entered (saved) when signi
ng off with [OK]
■ Changing of datavalue, step-by-step
Certain parameters can be changed step by step
or infinitely variably. This applies to Motor power
(parameter 102), Motor voltage (parameter 103)
and Motor frequency (parameter 104).
This means that the parameters are changed
bothasagroupofnumericdatavaluesandas
numeric data values infinitely variably.
MG.50.N4.02 - VLT is a registered Danfoss trademark
40
To Next Page
Loading...
