Parameter 3-36 CAM Master Table
Table 218: Parameter 3-36 CAM Master Table
Parameter type: Range, -2147483648 - 2147483647
Data type: Int32, Array [20]
Change during operation: True
N O T I C E
This parameter is only available with software version 48.XX.
Master position which together with the corresponding element of parameter 3-37 CAM Follower Table forms a CAM position point.
Parameter 3-37 CAM Follower Table
Table 219: Parameter 3-37 CAM Follower Table
Parameter type: Range, -2147483648 - 2147483647 [AbsolutePositionU-
nit]
Data type: Int32, Array [20]
Change during operation: True
N O T I C E
This parameter is only available with software version 48.XX.
Follower position which together with the corresponding element of parameter 3-36 CAM Master Table forms a CAM position point.
Parameter 3-38 CAM Curve Table
Table 220: Parameter 3-38 CAM Curve Table
Data type: Uint8, Array [20]
Change during operation: True
N O T I C E
This parameter is only available with software version 48.XX.
Connects the CAM table point with a straight line, corresponds to a fixed gear ratio between master and
follower.
Connects the CAM table points with an x-order polynomial where x is determined by the number of con-
secutive points of this type.
Connects the CAM table points with a 2
nd
order polynomial.
Connects the CAM table points with a 3
rd
order polynomial.
Connects the CAM table points with a 4
th
order polynomial. At least 2 consecutive CAM table points of
this type are required to use this selection.
AU275636650261en-000101 / 130R0334 | 141Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide
To Next Page
Loading...
Need help?
General