Danfoss VLT CANopen MCA 105 Programming Guide

Option
Function
[223]
On target
N O T I C E
This option is only available with software version 48.XX.
Positioning is completed and the on-target signal is sent when the actual position is within pa-
rameter 3-05 On Reference Window for the duration of parameter 3-09 On Target Time and the ac-
tual speed does not exceed parameter 3-05 On Reference Window.
[224]
Position limit
N O T I C E
This option is only available with software version 48.XX.
The position error exceeds the value in parameter 4-71 Maximum Position Error for the time set in
parameter 4-72 Position Error Timeout.
[225]
Position error
N O T I C E
This option is only available with software version 48.XX.
The position is outside the limits set in parameter 3-06 Minimum Position and parameter 3-07 Maxi-
mum Position.
[226]
Touch on target
N O T I C E
This option is only available with software version 48.XX.
The target position is reached in touch probe position mode.
[227]
Touch activated
N O T I C E
This option is only available with software version 48.XX.
Touch probe positioning is active. The drive monitors the touch probe sensor input.
[228]
Touch sensor found
N O T I C E
This option is only available with software version 48.XX.
The touch sensor has been detected.
[229]
Vir. master on ref.
N O T I C E
This option is only available with software version 48.XX.
The virtual master is running on the set reference.
[231]
In power lim. mot.
[232]
In power lim. gen.
[233]
In power limit
[234]
PE power off
AU275636650261en-000101 / 130R0334204 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT CANopen MCA 105 Specifications

General

Brand	Danfoss
Model	VLT CANopen MCA 105
Category	DC Drives
Language	English