Danfoss VLT CANopen MCA 105 Programming Guide

Option
Name
Description
[224]
Position error
N O T I C E
This option is only available with software version 48.2X and newer.
The position error exceeds the value in parameter 4-71 Maximum Position Error for the time set
in parameter 4-72 Position Error Timeout.
[225]
Position limit
N O T I C E
This option is only available with software version 48.2X and newer.
The position is outside the limits set in parameter 3-06 Minimum Position and parameter 3-07
Maximum Position.
[226]
Touch on target
N O T I C E
This option is only available with software version 48.2X and newer.
Target position is reached in touch probe position mode.
[227]
Touch activated
N O T I C E
This option is only available with software version 48.2X and newer.
Touch probe positioning is active. The drive monitors the touch probe sensor input.
[249]
Therm. sensor temp.
Parameter 13-11 Comparator Operator
Table 675: Parameter 13-11 Comparator Operator
13-11 Comparator Operator
Default value: Size related
Parameter type: Option, Array [10]
Setup: 2 setups
Conversion index: -
Data type: Uint8
Change during operation: True
Select the operator to be used in the comparison. This is an array parameter containing comparator operators 0–5.
Op-
tion
Name
Description
[0]
<
N O T I C E
If [20] Alarm number or [21] Warning number is selected in parameter 3-10 Comparator Operand, [0] <
cannot be selected in this parameter.
The result of the evaluation is true when the variable selected in
parameter 13-10 Comparator Operand
is smaller than the fixed value in parameter 13-12 Comparator Value. The result is false if the variable
selected in parameter 13-10 Comparator Operand is greater than the fixed value in parameter 13-12
Comparator Value.
[1]
≂ (equal)
The result of the evaluation is true when the variable selected in parameter 13-10 Comparator Operand
is approximately equal to the fixed value in parameter 13-12 Comparator Value.
AU275636650261en-000101 / 130R0334 | 387Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT CANopen MCA 105 Specifications

General

Brand	Danfoss
Model	VLT CANopen MCA 105
Category	DC Drives
Language	English