Danfoss VLT CDS 803 - Installation Environment

4.6 Changing Parameter Settings
Procedure
1. To enter the Quick Menu, press the [Menu] key until the indicator in the display is placed above Quick Menu.
2. Press [▵] [▿] to select the quick guide, closed-loop setup, compressor setup, or changes made.
3. Press [OK].
4. Press [▵] [▿] to browse through the parameters in the Quick Menu.
5. Press [OK] to select a parameter.
6. Press [▵] [▿] to change the value of a parameter setting.
7. Press [OK] to accept the change.
8. Press either [Back] twice to enter Status, or press [Menu] once to enter the Main Menu.
4.7 Accessing All Parameter via the Main Menu
Procedure
1. Press [Menu] until the indicator in the display is placed above Main Menu.
2. Press [▵] [▿] to browse through the parameter groups.
3. Press [OK] to select a parameter group.
4. Press [▵] [▿] to browse through the parameters in the specific group.
5. Press [OK] to select the parameter.
6. Press [▵] [▿] to set/change the parameter value.
Programming
Operating Guide | VLT® Compressor Drive CDS 803
AQ321748767627en-000101 / 130R0570| 37
Danfoss A/S © 2019.12