VLT
®
FCD Series
changing the selected parameter, following which the
underlining in line 4 will flash on the display. The
procedure for changing data depends on whether
the selected parameter represents a numerical data
value or a text value.
Changing a data value
If the selected parameter is a text value, the text
value is changed by means of the [+ / -] keys.
50.0 Hz
FREQUENCY
001 LANGUAGE
ENGLISH
The bottom display line will show the value that will
be entered (saved) when acknowledgment is given
[OK].
Change of numeric data value
If the selected parameter is represented by a numer-
ical data value, a digit is first chosen using the [< >]
keys.
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
09.0 HZ
The selected digit can then be changed infinitely
variably using the [+ / -] keys:
50.0 Hz
SETUP
1
FREQUENCY
130 START FREQUENCY
10.0 HZ
The chosen digit is indicated by the digit flashing.
The bottom display line shows the data value that
will be entered (saved) when signing off with [OK].
■ Manual initialisation
NB!:
Manual initialisation is n
ot possible on the
LCP 2 175N0131 control unit. It is, however,
possible to perform an initialisation via par. 620 Op-
eration mode:
The following parameters are not set to zero when
initialising via par. 620 Operation mode.
- par. 500 Address
- par. 501 Baud rate
- par. 600 Operating hours
- par. 601 Hours run
- par. 602 kWh counter
- par. 603 Number of power-ups
- par. 604 Number of overtemperatures
- par. 605 Number of overvoltages
- par. 615-617 Fault log
- par. 678Configure Control Card
MG.04.A1.02 - VLT is a registered Danfoss trade mark
28
To Next Page
Loading...
Need help?
General