Danfoss VLT FCM 355 User Manual

VLT
®
FCM Series
This value is updated every 320 ms.
527 Data read-out: FC therm.
(FC THERMAL)
Value:
0 - 100%
[0 - 100]
Function:
This parameter can be read out via the serial
communication port.
Description of choice:
Only whole numbers are displayed.
This value is updated every 160 ms.
528 Data read-out: Digital input
(DIGITAL INPUT)
Value:
Unit
Function:
This parameter can be read out via the serial
communication port.
Description of choice:
The value shown indicates the signal status from
the 4 digital terminals (2, 3, 4, and 5).
This value is updated every 20 ms.
533 Data read-out: External reference %
(EXT. REFERENCE)
Value:
-200.0 - +200.0 %
Function:
This parameter can be read out via the serial
communication port.
Description of choice:
The value stated gives, as a percentage, the sum of
external references (sum of analogue/bus/pulse).
This value is updated every 80 ms.
534 Data read-out: Status word, binary
(STATUS WORD [HEX])
Value:
Unit
Function:
This parameter can be read out via the serial
communication port.
Description of choice:
Indicates the status word transmitted via the
serial communication port.
537 Data read-out: INV. temperature
(INVERTER TEMP.)
Value:
Unit: ºC
Function:
This parameter can be read out via the serial
communication port.
Description of choice:
States the given temperature of the frequency
converter. This value is updated every 10 sec.
538 Data read-out: Alarm word
(ALARM WORD)
Value:
Unit
Function:
This parameter can be read out via the
serial communication port. See chapter on
"Warnings and alarms".
Description of choice:
States whether there is an alarm on the FC motor.
✭
= factory setting. () = display text [] = value for use in communication via serial communication port
MG.03.H3.02 - VLT is a registered Danfoss trademark
72

Danfoss VLT FCM 355 Specifications

General

Brand	Danfoss
Model	VLT FCM 355
Category	DC Drives
Language	English