1.
2.
3.
5.3.3 Configuring the IP Address
Procedure
Connect to the web server and click IP Setting.
Edit settings as required. To enable DHCP addressing, tick the DHCP checkbox.
Click Submit to send the new settings to the device.
5.3.4 Configure IoT Settings
The EtherNet/IP module supports soft starter status monitoring via IoT. The device cannot control or program the soft starter.
AN427641276310en-000101 / 175R118716 | Danfoss A/S © 2022.10
Device Configuration
EtherNet/IP Module
Installation Guide
To Next Page
Loading...
