ㆍDo not look directly at the projection beam with your eyes, because the strong beam may harm your eyes. RG2 IEC 62471-5:2015
ㆍDo not block or cover the heat dissipation holes of the device to avoid affecting the heat dissipation of the internal parts, and damaging
the device.
ㆍKeep away from humidity, exposure, high temperature, low pressure, and magnetic environments.
ㆍDo not place the device in areas susceptible to excessive dust and dirt.
ㆍPlace the device in a flat and stable station, and do not place the device on a surface that is prone to vibration.
ㆍDo not allow children to handle the device without supervision.
ㆍDo not place heavy or sharp objects on the device.
ㆍAvoid extreme vibrations, because these may damage the internal components.
ㆍPlease use the correct type of battery for the remote control.
ㆍOnly use attachments/accessories specified or provided by the manufacturer
(such as the exclusive power adapter, bracket, etc.).
ㆍDo not disassemble the device. The device should only be repaired by staff
authorized by the manufacturer.
ㆍPlace and use the device in a 0-40°C environment.
ㆍThe plug is considered as a disconnected device of the adapter.
ㆍThe adapter should be installed near the equipment, and should be easily accessible.
ㆍProtect the power cord from being walked on or pinched, particularly at the plugs, convenience receptacles,
and the point where this exits from the device.
ㆍUnplug this device if there are lightning storms or when unused for a long period of time.
ㆍWhere the power plug or an appliance coupler is used to disconnect the device, the disconnected device would remain readily operable.
ㆍNever touch the power cable or power connector with wet hands.
ㆍRisk of explosion if battery is replaced by an incorrect type.Dispose of used batteries according to local regulations.
Important Precautions
16
To Next Page
Loading...
