DB-70 Automatic Wheel Balancer 41 P/N 5900261 — Rev. A1 — January 2021
• If there is a value—.25, for example—you need to add that amount of Weight to the Outer
Plane for ALU 4).
q. To add Weight, break off the appropriate number of Adhesive Weight sections.
r. Manually turn the Wheel, watching the indicators to the left of the Outer Display Window.
The Indicators light up or go out as you move the Wheel.
s. When all of the Indicators are lit, press the Brake Pedal to hold the Wheel at that position.
t. Pull the backing off the Adhesive Weights, then add the Weight at Top Dead Center on the
Wheel (12 o’clock high) on the Outer Plane for ALU4. If you are adding Adhesive Weight with
multiple sections, center them on Top Dead Center.
u. Release the Brake Pedal.
v. Lower the Tire Cover to spin the Wheel again.
The Wheel is balanced when both the Inner and Outer Windows show 00.
It may take more than one time adding weights to get to 0.0 | 0.0.
To balance a Wheel using ALU5 Mode:
a. Make sure you are dressed appropriately: leather gloves, steel-toed work boots, back belts,
hearing protection, and ANSI-approved eye protection: safety glasses, face shield, or goggles.
b. Visually inspect the Balancer to make sure everything is in place. The Tire Cover should be
up
.
If you find any issues, fix them. If there are issues you cannot fix, refer to Troubleshooting.
c. Make sure the Wheel you want to balance is both clean and free of any weights that may have
been put on previously. If it is dirty, clean it. Remove any existing weights.
Important: When using Adhesive Weights, it is extremely important to
clean the Wheel
; the
cleaner the Wheel, the longer the Adhesive Weight stays in place.
d. Mount the Wheel on the Balancer.
Refer to Mounting a Wheel for mounting instructions, if needed.
e. Turn the Balancer Off and then back On, to reset, if required. The display should be flashing,
and –a- will appear in the Inner Display Window.
f. On the Control Panel, press the F button
until the ALU 5 Indication is lit.
g. Input the wheel parameters. Slide the inner
distance arm to touch the Inner Plane and
hold it there to automatically determine the
distance from the side of the Balancer and
To Next Page
Loading...