EasyManuals Logo

Dantherm CDP 50 User Manual

Dantherm CDP 50
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
25
EN
Introduction
The dehumidier requires very little attention for trouble free running. All the necessary safety
and control functions have been built in. The fan motor(s) and the compressor have permanent
lubrication and require no particular maintenance.
Monthly service
The air inlet lter is to be cleaned once a month. The lter is placed in a stand behind the grill in
the air inlet duct. Also drip tray and outlet should be cleaned so that water can run o freely.
Please follow this procedure to perform the monthly service:
Step Action
1 Unlock the two locks underneath the dehumidier
2 Dismount the front cap by lifting it up and take out the lter.
The lter is located on the rear of the front cap
3 Wash the lter in tepid soapy water or vacuum clean thoroughly.
If the lter is faulty, replace it.
4 Insert lter in the lter holder, reattach the cap and lock the two locks. (From Step 1)
Annual service
The dehumidier should be inspected once a year.
Please follow this procedure to perform the annual service:
Step Action
1 Remove the front from the dehumidier
2 Inspect the inside of the dehumidier
3 Vacuum clean the dehumidier to remove any dust or debris
Important: Vacuum clean the condenser thoroughly
4 If necessary wash the lamella evaporator in tepid soapy water if it is badly soiled
Service guide

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dantherm CDP 50 and is the answer not in the manual?

Dantherm CDP 50 Specifications

General IconGeneral
BrandDantherm
ModelCDP 50
CategoryDehumidifier
LanguageEnglish

Related product manuals