Dantherm CDP 50 - Error Code LP: Low Pressure; Error Code HP: High Pressure; Unlock Sequence Procedure

29
EN
Code LP If the Code LP (Low Pressure detection) is showm, the fault must be found and rectied.
The fault can only be dismissed by the unlock sequence which is initiated by pressing OK.
Code HP If the Code HP (High Pressure detection) is shown, the fault must be found and rectied.
The fault can only be dismissed by the unlock sequence which is initiated by pressing OK.
Unlock Sequence Code Lo and value c indicates that the unit is locked.
Press the Down button to unlock.
If no buttons are pressed within 5 seconds the display will return to previous fail state.
Code Un and value Lo shows Unlock option.
Press OK to conrm
OK
Error messages
OK