Dantherm CDP 50 - Data Log and USB Parameters; Data Log Parameters List

54
EN
Parameters Data log uses 2KB of backup SRAM (under battery) for data records.
Interval for storing records is 3 hours. State change to fail mode also invokes record store.
If whole space lled by record then new one will replace the oldest.
After connecting USB ash drive all collected records will be stored to le data_log.csv in CSV
format. Records won't be deleted from board so it is possible to get data onto several USB drives.
Data log record content:
Database parameter Size (bits) Output text CSV column
Work_time 32 <dd:mm:hh:ss> Timestamp
Amb_temp 8 <value> T_amb
Amb_int_temp 8 <value> T_amb_int
Amb_ext_temp 8 <value> T_amb_ext
Aux_temp 8 <value> T_aux
Cond_temp1 8 <value> T_cond
Evap_temp1 8 <value> T_evap1
Evap_temp2 8 <value> T_evap2
Temp_set 8 <value> T_set
Amb_hum 8 <value> RH_amb
Amb_int_hum 8 <value> RH_amb_int
Amb_ext_hum 8 <value> RH_amb_ext
RH_set 8 <value> RH_set
RH_Fan 8 <value> ExtFanSet
Evap_temp_err 1 "EVAP" Error
Cond_temp_err 1 "COND" Error
Aux_temp_err 1 "AUX" Error
Amb_int_err
1
"AMB_INT"
Error
Amb_ext_err
1
"AMB_EXT"
Error
SB_mode
1
"SB" Mode
Startup_mode
1
"STARTUP" Mode
DEH_mode
1
"DEH" Mode
Ice_mode
1
"ICE" Mode
LP_mode
1
"LP" Mode
HP_mode
1
"HP" Mode
Sens_mode
1
"SENS" Mode
AmbT_mode
1
"AMBT" Mode
AmbRH_mode
1
"AMBRH" Mode
Service_ena
1
"ENABLED" Mode
Data log/USB